The dominant cost factor is distance from the existing plumbing. Adding a bathroom adjacent to an existing wet wall, where the drain can tie into a nearby stack, is dramatically less expensive than placing one on the opposite side of the house. A half bath costs less than a full bath because there's no shower pan or waterproofing assembly involved. AMG Proline prices two or three viable locations so you can compare the tradeoffs before committing.

The best location is almost always determined by plumbing rather than preference. Look for space adjacent to an existing bathroom, kitchen, or laundry, since those already have drain and supply lines nearby. Common candidates include an oversized closet, the area beneath a staircase, a rear hall or mudroom, or part of an oversized bedroom. Stacking a new bathroom directly above or below an existing one is the most economical option of all.

It depends heavily on the age of the house and whether plumbing relocates. A newer subdivision home with fixtures staying in place sits at the lower end. A century-old home on the west or near east side costs more because plaster, non-standard framing, and original cast iron plumbing all require additional labor. We give a fixed written price after surveying the actual room, with allowances itemized so the drivers are visible.

Yes, in many homes. The constraint is headroom rather than floor area. A powder room needs roughly 60 inches of clearance above the toilet, and the space must accommodate a door swing plus enough room to stand at the sink. Under-stair locations work best when the staircase sits near existing plumbing. We measure the usable headroom at the first visit, since that single dimension usually decides feasibility.

Building codes generally require a minimum of about 15 inches of clearance from the center of the toilet to any side wall, and roughly 21 inches of clear space in front of the toilet, though local code governs. In practice that means a functional half bath can fit in approximately 3 by 6 feet, or about 18 square feet. Comfortable ones are larger, but tight powder rooms are frequently possible where homeowners assume they aren't.

It can. Adding a bathroom is a permitted improvement that increases a home's assessed value, and in Illinois assessors do factor completed permitted work into assessments. The increase is usually modest relative to the improvement's cost and the daily benefit of a second bathroom. Your township assessor's office can explain how improvements are treated locally, and that's worth a call before a large project if taxes are a concern.

Adding a bathroom requires a City of Aurora building permit, along with plumbing and electrical permits, and inspections at defined stages. New fixtures mean new drain, vent, and supply work, all of which is inspected before walls close. AMG Proline pulls the permits, schedules inspections, and meets the inspector on site, then supplies the documentation at closeout so your records are clean when you sell.

Yes, and it's a common request in multigenerational households. A curbless shower entry helps older adults and is equally safe for children. A comfort-height toilet suits adults, while a step stool handles the height difference for kids. Blocking behind the tile allows grab bars now or later without reopening walls. Slip-resistant flooring and good lighting benefit everyone, and none of it needs to look institutional.

Expect four to six weeks of on-site work for a new full bathroom, and three to four for a half bath, once permits are issued. Permitting itself adds time before anything starts, and design plus material selection typically adds two to four weeks. Additions take longer than remodels because framing, new drain and vent runs, and electrical rough-in all happen before finishing work begins.